Hardware Engineer 1 with Security Clearance

● RF Design and  Design, install, and test RF / SATCOM hardware (C‑, X‑, Ku‑, Ka‑, Q/V‑band) while accounting for atmospheric attenuation, ionospheric scintillation, rain‑fade, and polarization‑m ● Conduct site surveys, climb antennas, rack and align hardware, and operate earth‑terminal control consoles to establish and maintain wide‑band and satellite communication links. ● Perform preventive, scheduled, and corrective maintenance; troubleshoot on‑the‑spot malfunctions; apply anti‑jamming techniques and enforce safety/maintenance procedures. ● Use Keysight PNA‑X, FieldFox, Spec‑A, signal generators, oscilloscopes, and BER testers to measure S‑parameters, P1dB, TOI, NF, phase‑noise, group‑delay, and perform non‑linear analysis (IMD, spectral regrowth). ● Produce AutoCAD/Visio drawings, block diagrams, schematics, and technical design packages; ● Prepare engineering plans, as‑built documentation, test reports, and maintenance records; coordinate with cross‑functional teams (system architects, PMs, test sites). ● Travel up‑to 15 % worldwide to support installations, testing, and maintenance in remote or austere environments. ● Hands‑on proficiency with Keysight PNA‑X, FieldFox, Spec‑A, RF signal generators, spectrum/network analyzers, oscilloscopes, and BER testers. ● Experience developing preventive‑maintenance schedules, conducting equipment inspections, and authoring safety‑rule documentation. ● Excellent written and verbal communication; capable of producing technical reports, engineering plans, and briefing packages for multi‑service audiences. ● Proven problem‑solving record: troubleshooting complex RF hardware, analyzing data printouts, implementing corrective actions that improve performance and maintainability. ● Leadership/mentoring ability: lead inspection teams, supervise maintenance activities, and train site personnel. ● Ability to carry equipment, climb antennas, and rack hardware. ● Knowledgeable of RF design, installation, and test, with a focus on SATCOM systems. ​ Three (3) years experience as a HDE in integrated circuit or microelectronic component design or reverse engineering of the same is required.